The easiest part is the treble bleed apparatus.
The first consideration is the size of the humbucker. Make sure you know the size of your hole. Some humbuckers are a bit larger than others. Affinity Strats are also have notoriously shallow routs.
I've rewired a lot of Squiers, and I will tell you that they are often lacking in compartment space to fit all the wires and everything. Just take your time and be patient with it. Forcing it all in will inevitably result in earlier separations of the soldered connections.
We have a couple of examples of what you are shooting for ALMOST, as they lack the treble bleed and the 3 way dpdt.
So, I like the first picture better, since it is a bit closer to what you've got.
First, we're going to add the treble bleed to the volume knob.
Then, we will have a look at the 3 way switch.
While they aren't the same type of switch, these are, approximately the same thing and will share the same wiring.
A cleaner example.
From that information, I would posit this theoretical solution.
If ya want ill gladly send ya a copy of the diagram for future if someone ask for that type of setup hss 1 vol p/p 1tone 1blender 1 2p3t on on o configuration. By my count you get all normal pos in series and parallel then all pos using bridge in single coil then hit a switch and bring neck and mid into phase in series mode like a humbucker and boom new tone and hit pos 1 to combo with bridge for a dual humbucker style tone. Humbucker will be model of the pearly gates SD neck pickup. 7.8k 3.4h was inductance. Neck pickups are alnico 5 and 4.6k ohms. So should pair better then the original humbucker that was 12.8k and alnico5 magnet
Definitely found out fast routing was way to low lol. Used a step drill bit reamer type so 2 flute drilled put 3/8 inch then cleaned side walls and everything fit perfect. I have blender wired for b+n and b+n+m combos.. have wired in push pull for NxM combo in pos 1 and NxM+B in pos 5. Then a 3way dpdt for series parallel split coil on humbucker. Everything is wired up per a diagram I created had 3 pros double check the wiring. Humbucker needed changing so I ha e to wait for that to arrive hopefully Friday afternoon and install it in time to record a demo for Friday night guitar
(post is archived)