Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2025 Poal.co

812

Is anyone here fancied with wiring

Hss configuration 1 5way super switch 1 volume 500k push pull 1 250k blender pot 1 500k master tone pot 1 3 way dpdt 1 treble bleed kit

Goal

1-5 series humbucker with push-pull pot neck blended with blender

1-5 parallel humbucker with push-pull pot neck blended with blender

3way dpdt is used to split humbuck north coil neutral south coil

I understand how to hook up the push-pull and the 3way just not understanding how to properly ground everything or wire up the super switch and add treble bleed location and connect pots correctly to each other

Is anyone here fancied with wiring Hss configuration 1 5way super switch 1 volume 500k push pull 1 250k blender pot 1 500k master tone pot 1 3 way dpdt 1 treble bleed kit Goal 1-5 series humbucker with push-pull pot neck blended with blender 1-5 parallel humbucker with push-pull pot neck blended with blender 3way dpdt is used to split humbuck north coil neutral south coil I understand how to hook up the push-pull and the 3way just not understanding how to properly ground everything or wire up the super switch and add treble bleed location and connect pots correctly to each other

(post is archived)

You are currently inside a comment thread.
Click here to see all the comments (25).
[–] • 0 pt

To ground it properly, you look like you're almost there.

Personally, I'd solder the ground to the center of the pots and then solder the other end to the trem/bridge, cavity shield and jack ground. This doesn't always work out the greatest, for whatever reason, so, like I said, play with it before you put it in the guitar. It should be the right answer. Sometimes you need to leave out the cavity shield, or use it in lieu of the bridge. But... I only "settle" on that if it is a cheaper guitar.

The North Finish on the Humbucker, should go into the DPDT and out of the DPDT should go into the South Finish of the humbucker. I think.

https://pic8.co/sh/J7DBk5.png

Maybe this will help:

https://pic8.co/sh/t5tRXJ.png

[–] • 0 pt

Update I ended up just doing series parallel hb split with 3 way and with do some esle with blender and use push pull for something esle