Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2025 Poal.co

307

Once again, it's time for the FNGT!

If you don't know how this works, . That link will take you to another site to give you some additional information and tell you about some of our off-site features. That's also the site where we will host the weekly guitar threads, should Poal go down.

NOTE: That site is by invitation only. If you want an invite, and you're a regular participant, then just ask Crazy, or myself.

If you do know what's going on, you probably don't need to click that link - but you may want to, to make sure you know of the other features, such as the archive or a separate forum that's invite only.

Remember, we are guests here on Poal. Let's act like it. If you're interested in supporting Poal, then .

**Once again, it's time for the FNGT!** If you don't know how this works, [click this link](https://fngt.gq/index.php?page=intro). That link will take you to another site to give you some additional information and tell you about some of our off-site features. That's also the site where we will host the weekly guitar threads, should Poal go down. **NOTE:** That site is by invitation only. If you want an invite, and you're a regular participant, then just ask Crazy, or myself. If you do know what's going on, you probably don't need to click that link - but you may want to, to make sure you know of the other features, such as the archive or a separate forum that's invite only. Remember, we are guests here on Poal. Let's act like it. If you're interested in supporting Poal, then [you can donate](https://poal.co/donate).

(post is archived)

You are currently inside a comment thread.
Click here to see all the comments (235).
[–] • 0 pt

If the hole was large enough, yes. A small 1/8" hole ain't gonna let much heat into it, nor add that much surface area.

[–] • 0 pt

its just corroded in there to damned tight, it doesnt want to come out

[–] • 0 pt

If it were me, I'd be drilling on it.

Well, no... I'd have someone else do it for me. I don't know if we'd have gone cutting the nut off or anything like that - but I wasn't there, so I don't know.

[–] • 0 pt

They figured if the cut the bolt off at the frame, it would come right out under the frame where the bolt is with heat and hammer. The bolt goes up three inches above the frame holding the control arm and sub frame. The top half of the bolt came off after cutting it at the frame. But the smooth part going through the frame is stuck like a bitch.